Articles Search Results

Q. I have already installed and grouted 12x12 granite for my kitchen counter top, BUT how do I polish the edge like the top (or at least close to). It seems to be a secret, I cannot find how to from the net. Please help! Thank you so much! A. This is... Read More

[Fabrication Company] installed Kashmir Gold granite kitchen countertops in our home and the surface tops are yellowed and the bullnose edges are without yellow. We complained immediately during installation and they promised that their polish would... Read More

V-edge is a term used by professional stone refinishes to describe the shiny edge that may remain after polishing. V-edges result from uneven tiles. When the tile is polished, the polishing pad can not reach the lower edge of the uneven tile, and... Read More

You may want to recommend to your customer that having the edges rounded would help prevent further chipping. The edge can be rounded using a course diamond abrasive on a small electric hand machine. You can also put a profile on the edge using a... Read More

The same problems with edges on marble also apply to granite. See question #62. Try to avoid edges when polishing grnite, it can be very time consuming and very hard work. It may prove difficult to feather into the edge when polishing granite. If you... Read More

The best way is not to polish them at all. Edges and corners rarely require any work since they are not subject to foot traffic. If for some reason you need to hone or polish them, there is a machine available that has a triangular pad that can get... Read More

The shiny edges are what we call “v” edges, since they normally form a “v” along two edges of the tile. You are correct in that these “v” edges are areas that are lower than the adjacent tile and your diamonds are not touching these areas... Read More

If these scratch patterns are what I think they are then they probably occurred during fabrication. Some polishing machines have ten inch diameter polishing heads. It is not unusual to have these patterns show up after the floor has been polished.... Read More

The reason you require all the water is because your machine is too fast. Slow the machine down to the same speed as your floor buffer and you will require a lot less water. If your machine is not equipped with variable speed you can purchase a... Read More

Simply, you did not feather properly. This halo is the result of not properly overlapping you steps or you did not overlap enough. You will need to overlap at least two inches on each grit. Proper planning is a must if you want to avoid this halo.... Read More